© 2023 by Clipped. Proudly created with Wix.com

  • Twitter B&W
  • Facebook B&W
  • Pinterest B&W
  • Google+ B&W

Injecting Instructions

January 5, 2016

 

Injecting

Actual injection takes place by pinching the skin loose from the muscle and raising it so that a needle can be inserted between the skin and muscle. This is not a deep injection and melanotan should be injected in the fat layer of the skin.
 

You also need to consider your injection site, the most popular is the stomach, followed by the leg and buttocks.

If you have a low body fat percentage you may have to inject at a 45 degree angle or use short needles.

If you can pinch a small amount of fat then you can inject at a 90 degree angle.

 

Pre-Loading

Pre-loading can be advantageous when using sterile injectable water or sodium chloride or if you wish to save time later.

This is the best method for when using sodium chloride as it eliminates risk of contamination.

Gather your supplies...

*  1 vial of reconstituted Melanotan

*  All of your syringes

*  A few alcohol swabs

  1. Start by wiping your Melanotan stopper and then insert the syringe.

  2. Turn the vial upside down and withdraw your required dose.

  3. Return the right way up and remove the syringe.

  4. Carefully replace the cap.

  5. Repeat for all of your syringes. If your swab becomes dry then replace it, one swab should manage about 10 syringes

  6. Place your syringes in a zip lock bag and place in the freezer.

 

  1. When ready to administer your dose take a syringe out of the fridge and allow to thaw, this should only take a few minutes. You can hold it in your hand to speed up the process.

  2. Find a suitable injection site and wipe with the alcohol swab.

  3. Insert the needle into your skin in a firm and swift movement.

  4. Slowly push the plunger until all the liquid is gone.

  5. Remove the needle in a similar fashion as above and dispose.

  6. A small amount of blood can be expected, just use the swab to give it another wipe. 

 

Normal Injections

This is the easiest method and is advised when using bacteriostatic water.

You can use this method with sterile injectable water or sodium chloride, however, you must ensure the vials are kept sterile at all times.

The smallest amount of bacteria can multiply to harmful levels in hours to days depending on storage.

Gather your supplies...

*  1 vial of reconstituted Melanotan

*  1 syringes

*  1 alcohol swab

  1. Start by wiping your Melanotan stopper and then insert the syringe.

  2. Turn the vial upside down and withdraw your required dose.

  3. Return the right way up and remove the syringe.

  4. Find a suitable injection site and wipe with the alcohol swab.

  5. Insert the needle into your skin in a firm and swift movement.

  6. Slowly push the plunger until all the liquid is gone.

  7. Remove the needle in a similar fashion as above and dispose.

  8. A small amount of blood can be expected, just use the swab to give it another wipe.

 

 

 

Please reload

Featured Posts

I'm busy working on my blog posts. Watch this space!

Please reload

Recent Posts

March 25, 2019

March 18, 2019

November 14, 2018

April 6, 2018

March 27, 2018

March 27, 2018

March 27, 2018

Please reload

Archive